Compatible for Porsche Conrods

Discover engine piston high quality and performance H-beam connecting rods at Maxpeedingrods. All other variables being equal, Our H-beam rods are the strongest design when bending stress is considered. We provide a huge variety of sport performance Forged 4340 EN24 Titanizing conrod to ensure that you have every conrods option available to your car. Maxpeedingrods con rods with ARP bolts allows the engine to rev faster and rev higher.

Buy products related to conrods compatible for Porsche car, choose the best fitment connecting rods for your compatible for Porsche series car. Including compatible for Porsche 911 Carrera, compatible for Porsche 996, compatible for Porsche 993 and more.

Showing 1 to 4 of 4 (1 Pages)
  • What is A Connecting Rod?

    A connecting rod is an engine component that transfers motion from the piston to the crankshaft and functions as a lever arm. Connecting rods are commonly made from cast aluminum alloy and are designed to withstand dynamic stresses from combustion and piston movement. H-Beam Connecting Rods are a little bit heavier, stiffer, more rigid and stronger than I-Beam, so they are the priority selection for high horsepower and high cylinder pressures.

  • What Does A Connecting Rod Do?

    A connecting rod links the piston to the crankshaft. The rod itself is rigid. However, on each end are pivot points with bearings where it attaches to the crank and a pin where it attaches to the piston. This allows the piston to continue to move up and down while the rod moves with the rotation of the crankshaft. The connecting rod needs to be strong enough to handle the downward force of the piston during combustion as well as the force against the crankshaft at the rod journal.

  • How To Measure Connecting Rod Length

    An engine connecting rod length is determined by measuring the distance between the center points of the piston pin bore and the crankshaft journal bore.

  • How To Install Connecting Rods To Crankshaft

    Once you have installed the assembled connecting rods and pistons through the engine block bores, the next step is installing the connecting rods to the crankshaft stroke sections. The connecting rod should have the matching cap and correct cap orientation for assembly. Correct size rod bearings must be installed into the cap and rod. Next, tighten the rod bolts with Plastigauge installed. Remove the the rod from the crank and and check the Plastigauge to confirm correct clearance and tolerances. Once correct, reinstall the connecting rods onto the crankshaft and tighten according to the manufacturer's connecting rod torque specs.